● Perfect adherence.

● Allows installation of tiles from top towards the bottom.

● Easily trowelable.

● Preparation of Substrates

● Substrates must be sound, free from oil, grease, and sufficiently dry. Cementitious substrates must be cured.

● Cracked plasters mortar and cement residues must be scraped off the surface.

● The porous surfaces should be wetted and must be left to dry before application.

● The surface should be primed with (Primer) depending on the absorbency of the substrate before application.

● Wipe the back sides of tiles with water if dusty.

● Pour 1010 Sulikim on the amount of clean water specified in the technical table slowly and mix to obtain a homogeneous paste free from lumps. A low speed mixer is recommended to mix. Do not add any additive which is not mentioned in the instructions for the application.

● Allow to stand for 5 – 10 minutes to mature. After 1-2 minutes remixing, the paste is ready for application.

● Consumption is 2-4 kg/m2

● Consume the prepared mortar within 6 hours.

● Spread the mortar onto the substrate with a notched trowel of which notch size is appropriate to the tile dimension. To obtain a good adhesion first apply a thin coat of 1010 Sulikim with the flat side of the trowel, then notch with the toothed side of the trowel.

● Open time is 20 minutes. Install the tiles within this period with a firm pressure. Unfavourable climatic conditions (high temperature, low humidity, wind, etc.) can reduce this time to just a few minutes, If this period is exceeds, scratch and discard the mortar.Health and Safety – Wear Gloves– Wear Mask and Goggles08 SuliKimCeramic Tile Adhesive C1T

● Clean tools and hands with water, and surfaces with a damp cloth.

● Dispose mortars of which the pot life is expired.

● Tiles installed with Sulikim must not be subject to water for at least 24 hours and must be protected from frost and strong sunlight for at least 5-7 days after installation.

● Time required for grouting on walls is 10 hours and on floors is 36 hours.

● Floors can be opened to light foot traffic after 36 hours.

● The surface should be protected from air stream during and after the application.

● It should not be applied in rainy weather and the applied surface should be protected from rain in 24 hours.

● The mortar should not be exposed to direct sunlight and the mixture should be made with warm water.

● Application temperature should be between °5+C and °35+C.

● Since it contains cement, it irritates the eyes, respiratory system and skin. For further information refer to the safety data sheet.

● The consumption values in the table refers to an average consumption amount. It may vary depending on the application conditions and surface properties.

● Packages should be kept dry and cool at between °5+C and °35+C in moisture free conditions. Avoid direct sunlight.

● Packages should be protected from water, frost and adverse weather conditions.

● Do not stack more than 10 bags on top of each other.

● Shelf life is maximum 12 months conditional to complying with the above mentioned conditions.

Packaging

● 20 kg multi-ply paper bags.

Certificates of Quality

Class C1T

C: Cementitious

1: Standard

T: Reduce slip